|
How to apply the stickers |
|
|
How the Sticker is made
The adhesive is preserved between two protective sheets: the Support paper and the Application paper.
The Support paper is the paper on which the Sticker is glued.
The Application paper is slightly transparent, allowing the image to be seen, and is removed only at the end of application.
|  |
|
|
Stickers with more than one image
If the sheet contains more than one image and you wish to position the images at varying distances, for example in order of family kits, you can simply roughly cut out each image using a pair of scissors.
Cut the Support paper and Application paper together, without separating them and pay careful attention not to cut the designs (the stickers are already precut). |  |
|
|
How to apply small Stickers |
|
|
 | Carefully separate the Support paper and Application paper.
The adhesive must remain attached to the Application paper. |
|
|
 | Arrange the Stickers in the chosen position, with the adhesive side facing the surface you wish to decorate. |
|
|
 | Use the supplied spatula on the Application paper to firmly smooth out the design from the centre out towards the borders. |
|
|
 | Carefully remove the Application paper, pulling it gently at a 180° angle. The Sticker will remain glued to the surface you wish to decorate. |
|
|
 | Use your hand to press the Sticker to the wall, in particular at the borders, in order to ensure it completely adheres. If some small bubbles remain, pierce them with a pin in order to release the trapped air.
|
|
|
How to apply large Stickers. |
|
|
 | Position the adhesive with the Support and Application paper on the chosen surface, paying careful attention that the side with the design is facing you. Use masking tape to attach the adhesive to the wall, applying the masking tape accross the centre of the adhesive. |
|
|
 | Separate the upper half of the Application paper from the Support paper, only up until the masking tape. The Sticker will remain glued to the Application paper. |
|
|
 | Using a pair of scissors, cut off the upper half of the Support paper which has already been detached from the Sticker. Pay careful attention not to cut the Sticker or the Application paper! |
|
|
 | Now, with the assistance of the supplied spatula, stick the upper half of the Application paper with the Sticker, onto the surface you wish to decorate. Use the spatula to firmly smooth out the design from the centre out towards the borders. |
|
|
 | Carefully remove the masking tape.
Gently remove the Support paper from the lower half of the adhesive as well.
|
|
|
 | Beginning with the upper half which has already been glued to the wall, proceed to smooth out the lower half with the spatula, thus completely attaching the Sticker to the surface you wish to decorate. Use the spatula on the Application paper to firmly smooth out the design from the centre out towards the borders. |
|
|
 | Remove the Application paper, pulling it gently at a 180° angle, in order that the Sticker remains glued to the surface you wish to decorate. |
|
|
 | Use your hand to press the Sticker to the wall, with particular emphasis on the borders.
If some small bubbles remain, pierce them with a pin in order to release the trapped air. |
|
|
